TEMCo TH0390 - Kit de destornillador de punzón de extracción manual (juego) para tamaños de orificios de conductos eléctricos de ½ pulgada a 2 pulgadas (tamaño de conducto de 1/2 "-2")

Manual drive knockout punches, for use with ratchet, wrench, or electric driver. Conduit punch sizes: 1/2",3/4",1",1-1/4",1-1/2",2"

Capacity: Mild steel plate through 10 gauge (3.5mm) Works to punch Mild steel, Brass, Copper, Aluminum (soft alloys only), Fiberglass and plastic.

Slug splitting design on punches allows for easier slug removal - the smooth operation leaves the round hole with clean edges and a uniform size.

Manual punch works great in tight areas. Punch dies feature laser engraved alignment marks for easy and precise positioning.

Kit comes in a rugged storage case with a 19mm Socket, to be used with 1/2" ratchet. Storage case is designed with a secure-closing lid for keeping all the pieces neatly organized for easy transport.

Draw Stud threads are compatible with THA001 and THA013 draw studs, allowing for use on TEMCo hydraulic drivers TH0004 and TH0037 Compatible with GREENLEE and other domestic punch tooling 3/4"-16 threads.

Traditional style knockout punches suffer from a problem where the slug that is left over after punching often deforms within the die set, locking itself into place around the draw stud or in the die. It is very frustrating and time consuming to stop your work and pry the slug from your tool.

The new slug-splitting design of the TEMCo knockout punches solves this issue by integrating a secondary cutter face that slices the slug into two parts, eliminating the ability for it to bind in the tool. When you release the dies, the cast off slug bits simply fall out, and you're ready to move on to your next hole.